MT MT80i Installation Manual

Introduction to the MT MT80i Installation Manual

The MT MT80i is a GPS tracking device designed to offer precision and reliability in various applications. This installation manual guides you through the necessary steps for the proper setup of your device, ensuring that all functionalities are maximized.

We will begin with the correct positioning of the GPS, a crucial factor for optimizing signal reception. The installation should be done in a location with good visibility to the sky, avoiding obstructions that may interfere with communication. Additionally, the device's power supply should be carried out according to the manufacturer's specifications, ensuring that the MT80i operates continuously and without interruptions.

Another important point is the insertion of the SIM card. Ensure that the SIM card is properly installed and compatible with the chosen communication network. After installation, it is recommended to perform a functional check of the device to confirm that all configurations have been applied correctly and that tracking is active.

For an even more efficient tracking experience, consider the Trackar platform, which offers a one-time payment system and features that enhance the use of the MT MT80i. Monitor and manage your location information conveniently and effectively.

SMS Commands

2. Carrier APN Configuration

It is essential that the APN, username, and password information are properly updated according to the chip carrier used. Each carrier has its specifications.

SET APN=ALLCOM.BR:ALLCOM:ALLCOM

SET APN=JBGPRS.ALGAR.BR:ALGAR:ALGAR

SET APN=META.COM.BR:VIVO:VIVO

SET APN=SMART.M2M.VIVO.COM.BR:VIVO:VIVO

SET APN=TRANSMEET.BR:TRANSMEET:TRANSMEET

3. Communication Time Configuration with Ignition On

The transmission interval can be adjusted in seconds. The default value is 60 seconds, which determines the communication frequency while the vehicle is in motion.

SET T3 FREQ=060

4. Communication Time Configuration with Ignition Off

This time is adjustable in minutes and defines the communication interval when the vehicle is stationary. The default is 55 minutes.

SET HEARTBEAT=55

These settings are recommended to optimize the performance of the tracker.

Special commands

1. DNS and Port Configuration

To ensure a stable connection, it is recommended to use the domain's DNS. You must configure the servers as indicated below for the tracker to work correctly.

SET URL=central.trackar.com.br:6216

SET URL=central.trackar.com.br:6216 ### 5. Special Commands

Here are some commands that can be used to manage and monitor the tracking device.

GET NTW

GET INFO

GET PROG

GET LOCATION

SET SLEEP_MODE=1

WAKE_UP

SET IGNITION_DETECTION=0

SET ENGINEV=13200

GET IGNITION_DETECTION

SET RELAY=1

SET RELAY=0

REBOOT