MT MT02 Installation Manual

Introduction to the MT MT02 Installation Manual

The MT02 model from the MT brand is an advanced solution for GPS tracking, providing precise real-time monitoring. This installation manual has been designed to guide you through the essential steps for the physical implementation of the device, ensuring that you make the most of its functionalities.

In the initial phase of installation, it is crucial to determine the ideal position for the GPS. The location should ensure clear signal reception, avoiding obstructions that may compromise tracking effectiveness. Additionally, the power supply must be connected correctly, following the manufacturer's specifications to avoid damage to the device.

The SIM chip also plays a fundamental role in the device's communication. Ensure that it is installed correctly and has an active data plan to guarantee continuous information transmission. After installing the components, we recommend performing a complete system check to ensure that all elements are functioning in perfect harmony.

To further optimize your tracking experience, consider using the Trackar platform, which offers a one-time payment and robust resources for fleet management and monitoring. With the MT MT02 and Trackar, you will always be one step ahead in supervising your assets.

SMS Commands

1. DNS and Port Configuration

To ensure your device's connectivity, it is essential to correctly configure the DNS and server port. Use the following address as a reference for the server configuration: central.trackar.com.br:6216. This address should be replicated for the three servers, ensuring a stable connection.

SET URL=central.trackar.com.br:6216

2. Carrier APN Configuration

The correct APN configuration is crucial for the tracker to function. The APN, username, and password information must be adjusted according to the SIM card and carrier used. Below are the necessary commands for APN configuration:

SET APN=ALLCOM.BR:ALLCOM:ALLCOM

SET APN=JBGPRS.ALGAR.BR:ALGAR:ALGAR

SET APN=META.COM.BR:VIVO:VIVO

SET APN=SMART.M2M.VIVO.COM.BR:VIVO:VIVO

SET APN=TRANSMEET.BR:TRANSMEET:TRANSMEET

Make sure to enter the correct information according to your carrier.

3. Communication Time Configuration with Ignition On

Adjust the transmission interval while the ignition is on. The time is configurable in seconds. The default value is 60 seconds, which determines the device's communication frequency.

SET T3 FREQ=060

4. Communication Time Configuration with Ignition Off

Set the communication interval when the ignition is off. This time is adjustable in minutes, with 55 minutes being the default interval. This ensures that the device continues to function even when the vehicle is not in use.

SET HEARTBEAT=55

Special commands

5. Special Commands

Below are some special commands that can be used to manage the device:

GET NTW

GET INFO

GET PROG

GET LOCATION

SET SLEEP_MODE=1

WAKE_UP

SET IGNITION_DETECTION=0

SET ENGINEV=13200

GET IGNITION_DETECTION

SET RELAY=1

SET RELAY=0

REBOOT