MT MT01 Installation Manual

Introduction to the MT MT01 Installation Manual

Welcome to the installation manual for the MT MT01 GPS. This device is an advanced solution for monitoring and tracking vehicles, offering precision and reliability. In this section, you will find detailed guidance on the physical installation of your GPS, addressing crucial aspects such as the ideal position of the device, connection to power, SIM card insertion, and functionality verification.

Proper installation of the MT MT01 is essential to ensure the efficient performance of the tracker. The choice of GPS position should be made carefully, avoiding obstructions that may interfere with the signal. The power supply must be properly connected to ensure that the device operates without interruptions. Regarding the SIM card, installation should be performed following specific instructions to ensure that data communication is established correctly.

Finally, verifying the GPS functionality is an essential step that ensures all settings are correct and that the device is ready to operate. Follow the steps and ensure that the MT MT01 is properly installed and functional.

To further optimize your tracking experience, consider using the Trackar platform, which offers a one-time payment and advanced functionalities for real-time monitoring.

SMS Commands

1. Server Configuration

It is recommended to use a domain DNS for the server configurations. You should set the server address according to the instructions below.

SET URL=central.trackar.com.br:6216

2. Carrier APN Configuration

The APN, username, and password information need to be updated with the correct data, as they vary according to the carrier and the chip used. Make sure to enter the appropriate information to ensure connectivity.

SET APN=ALLCOM.BR:ALLCOM:ALLCOM

SET APN=JBGPRS.ALGAR.BR:ALGAR:ALGAR

SET APN=META.COM.BR:VIVO:VIVO

SET APN=SMART.M2M.VIVO.COM.BR:VIVO:VIVO

SET APN=TRANSMEET.BR:TRANSMEET:TRANSMEET

3. Communication Time Configuration

Adjust the communication time based on the ignition situation. The time can be configured in seconds for ignition on and in minutes for ignition off, allowing for better battery consumption management.

SET T3 FREQ=060

SET HEARTBEAT=55

Special commands

4. Special Commands

Here are some special commands that can be used to manage the device more efficiently.

GET NTW

GET INFO

GET PROG

GET LOCATION

SET SLEEP_MODE=1

WAKE_UP

SET IGNITION_DETECTION=0

SET ENGINEV=13200

GET IGNITION_DETECTION

SET RELAY=1

SET RELAY=0

REBOOT