MT MT-1 Installation Manual

Introduction to the MT-1 GPS Installation Manual

Welcome to the installation manual for the MT-1 GPS from the MT brand, an innovative solution for monitoring and tracking. This guide has been designed to assist you in the physical installation of your device, ensuring that you make the most of its features.

The correct positioning of the GPS is essential for optimal performance. We recommend that the device be installed in a location where it has a clear view of the sky, avoiding obstructions that may interfere with the signal. Additionally, the device's power supply should be securely connected to the appropriate power source to prevent operational failures.

Do not forget to insert the SIM card correctly, as it is essential for the GPS to communicate with the tracking platform. After installation, it is important to perform a final check to ensure that all components are functioning correctly and that the device is ready for use.

Take the opportunity to explore the Trackar platform, which offers an efficient tracking service for a one-time payment. Start monitoring your assets easily and securely!

SMS Commands

1. DNS and Port Configuration

To ensure proper communication of your tracker, it is essential to configure the DNS correctly. Use the recommended domain so that the device operates without interruptions.

SET URL=central.trackar.com.br:6216

Make sure all servers are configured with the same URL.

2. Carrier APN Configuration

Configuring the APN is crucial for the operation of the tracker. The APN, username, and password information must be adjusted according to the carrier of the chip used. Check the correct information before proceeding.

SET APN=ALLCOM.BR:ALLCOM:ALLCOM

SET APN=JBGPRS.ALGAR.BR:ALGAR:ALGAR

SET APN=META.COM.BR:VIVO:VIVO

SET APN=SMART.M2M.VIVO.COM.BR:VIVO:VIVO

SET APN=TRANSMEET.BR:TRANSMEET:TRANSMEET

The information may vary according to the carrier.

3. Communication Time with Ignition On

The transmission interval with the ignition on can be adjusted as needed. The value is configured in seconds and should be defined according to the desired use of the tracker.

SET T3 FREQ=060

The standard time of 60 seconds is just a suggestion.

4. Communication Time with Ignition Off

Just like with the ignition on, the communication time with the ignition off can also be adjusted. This time is configured in minutes.

SET HEARTBEAT=55

An interval of 55 minutes is recommended to save battery.

Special commands

5. Special Commands

There are commands that can be used to effectively manage and obtain information from the device. Use them as needed.

GET NTW

GET INFO

GET PROG

GET LOCATION

SET SLEEP_MODE=1

WAKE_UP

SET IGNITION_DETECTION=0

SET ENGINEV=13200

GET IGNITION_DETECTION

SET RELAY=1

SET RELAY=0

REBOOT

These commands allow comprehensive control of the device.