Concox GT06 Installation Manual

Introduction to the Concox GT06 Installation Manual

The Concox GT06 is a GPS tracking device widely recognized for its efficiency and reliability. This installation manual aims to guide you through the essential steps for the physical setup of your device, ensuring that you achieve the best possible performance.

Proper installation of the Concox GT06 involves choosing the ideal position for the GPS, ensuring that it has good signal reception and is protected from the elements. Additionally, the device's power supply must be done safely, using the recommended source to avoid damage. It is also crucial to correctly insert the SIM chip, which will allow the device to communicate with the network. Finally, we will perform a functionality check of the Concox GT06 to ensure that all settings are correct before full use.

Take advantage of all the features that the Concox GT06 has to offer and maximize the efficiency of your tracking. For even more efficient management, try the Trackar platform, which offers a one-time payment system to facilitate your tracking experience.

SMS Commands

1. Time Zone Configuration

The first step to configuring your GT06 tracker is to correctly set the time zone. This is essential to ensure that all location data is accurate and synchronized with local time.

801#W0#

2. Carrier APN Configuration

It is essential that the APN, username, and password settings are adjusted according to the specifications of the chip provider and the carrier. This ensures that the device has access to the data network.

802#claro.com.br#claro#claro

802#smart.m2m.vivo.com.br#vivo#vivo#

802#transmeet.br#transmeet#transmeet#

802#zap.vivo.com.br#vivo#vivo#

The information should be updated according to the carrier used.

3. DNS and Port Configuration

In this step, you need to set the DNS servers and the port that the tracker will use to connect. It is important to have the correct data to ensure efficient communication.

803#central.trackar.com.br#6023#

4. Transmission Time Setting in Motion

Here you can adjust the transmission interval when the device is in motion. The time can be set between 10 and 60 seconds, allowing you to adapt the update frequency as needed.

730#60#

5. Transmission Time Setting When Stationary

This setting allows you to adjust the transmission interval when the device is stationary. The interval can vary from 1 to 60 minutes, helping to save battery when there is no movement.

SUP#55#

It is recommended to finalize the settings after this step.

Special commands

6. Special Commands

Below are some special commands that can be used to manage and monitor the device.

886#

CIP#

902#

222#

333#

930#

666#

C10#

901#

940#

These commands allow checks, locks, unlocks, and reboots of the device.