Coban TK909 Installation Manual
Introduction to the Coban TK909 Installation Manual
The Coban TK909 is a robust and versatile GPS tracking device, ideal for monitoring vehicles and assets in real-time. Proper installation of this device is essential to ensure its proper functioning and maximize its functionalities. In this manual, we will cover the main points for the physical installation of the Coban TK909, including the ideal position of the GPS, power connection, SIM card insertion, and verification of the device's operation.
Choosing the position of the GPS is crucial to ensure efficient signal reception. It is recommended to install the device in a location where it has a clear view of the sky, avoiding obstructions such as metal or dense surfaces that may interfere with communication. The device's power supply should be done carefully, ensuring that the connection is firm and secure. The installation of the SIM card should also be performed correctly, ensuring that the device connects to the mobile network for data transmission.
After installation, it is important to conduct a complete verification of the Coban TK909's operation to ensure that all functionalities are working as expected. For even more efficient management of your trackers, consider using the Trackar platform, which offers a one-time payment service, facilitating continuous and real-time monitoring of your assets.
SMS Commands
1. Start of Configuration
To start using the tracker, it is necessary to perform the initial configuration of the device. This step is crucial to ensure that all functionalities operate correctly.
begin123456
2. Time Zone Configuration
It is essential to adjust the time zone of the tracker so that location information is accurate. The following command must be sent to configure the desired time zone.
time zone123456 0
3. APN Configuration
Configuring the APN is essential for the tracker to connect to the carrier's network. The APN, username, and password information varies according to the chip provider used. Make sure to enter the correct data.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
To ensure efficient communication, it is necessary to configure the DNS servers and ports. These parameters must be defined according to your service provider's specifications.
Server 01: Server 02: Server 03:
5. Vibration Alarm Activation
The vibration alarm can be activated to alert you about unexpected movements of the device. Use the command below to enable this function.
shock123456
6. Tracking Activation
To start tracking the device, it is necessary to activate this function using the appropriate command. This will allow you to monitor the location of the tracker in real-time.
tracker123456
7. GPRS Transmission Activation
The communication of the tracker with the server is done via GPRS. To ensure that this functionality is active, send the indicated command.
gprs123456
8. Transmission Time Definition
The transmission time can be adjusted as needed. The default is 60 seconds while the equipment is in motion. Use the command below to set the desired interval.
upload123456 060
9. Sensor Sleep Mode
The tracker can enter sleep mode after 5 minutes of inactivity. It will be activated again upon detecting any movement, vibration, or receiving an SMS or call. This function helps to save battery.
sleep123456 shock
Special commands
Special Commands
There are additional commands that can be used for various functions of the tracker. Check the list below:
G123456#
where
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment