Coban GPS303-G Installation Manual

Introduction to the Coban GPS303-G Installation Manual

The Coban GPS303-G is a vehicle tracking device designed to offer efficiency and reliability in fleet monitoring. Proper installation is essential to ensure that the device functions correctly and provides accurate data about the vehicle's location. In this manual, we will cover the essential steps for the physical installation of the GPS303-G, including the ideal position for installation, connection to the power source, insertion of the SIM card, and verification of the device's operation.

To begin, it is important to choose a discreet and secure location within the vehicle to mount the GPS303-G, ensuring that it is protected from external interference while still having an optimized GPS signal. The device's power supply should be securely connected to the vehicle's battery, ensuring that the GPS receives the necessary energy for its operations. The insertion of the SIM card should be done carefully, ensuring that the card is properly positioned for effective communication. After installation, it is crucial to perform a check to confirm that the device is functioning correctly and sending accurate information.

Make the most of your Coban GPS303-G and transform your fleet management with the Trackar platform, which offers a one-time payment and a complete solution for vehicle monitoring.

SMS Commands

1. Start Equipment Configuration

To begin using the device, initial configuration is necessary. This will ensure that all functions operate correctly.

begin123456

2. Time Zone Configuration

Adjusting the time zone is essential for the tracker to record the correct time. This command allows you to set the desired time zone.

time zone123456 0

3. Carrier APN Configuration

Configuring the APN (Access Point Name) is crucial to ensure the device's connectivity. APN, username, and password information must be entered correctly, as they vary by carrier.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

Make sure to use the correct information from your carrier.

4. DNS and Port Configuration

To optimize the communication of the tracker, it is necessary to configure the DNS servers. Enter the addresses of the servers as needed.

Server 01, Server 02, Server 03: enter the appropriate values.

5. Vibration Alarm Activation

This command activates the vibration alarm of the tracker, which can be useful for alerts in specific situations.

shock123456

6. Activate Tracking

For the tracker to start monitoring the device's location, the tracking function must be activated.

tracker123456

7. GPRS Transmission Activation

Activate data transmission via GPRS so that the tracker can send location and status information.

gprs123456

8. Set Transmission Time

You can adjust the data transmission interval. The default is 60 seconds when the equipment is in motion.

upload123456 060

The time can be configured as needed.

9. Sleep Mode by Sensor

This mode allows the tracker to enter a power-saving state after 5 minutes of inactivity. Any movement or vibration will cause the device to return to the active state.

sleep123456 shock

The tracker can be activated by movement, SMS, or call.

Special commands

Special Commands

Here are some additional commands that may be useful for managing the tracker.

G123456#

where

gprs123456 0

sensitivity123456 + selecionar número 1, 2 ou 3!

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456