Coban GPS105B Installation Manual
Introduction to the Coban GPS105B Installation Manual
The Coban GPS105B is an advanced vehicle tracking device designed to provide security and real-time monitoring. The physical installation of this equipment is crucial to ensure its effective operation. In this section, we will cover the main aspects of installation, including the ideal position for the GPS, connection to power, insertion of the SIM card, and verification of the device's operation.
When choosing the position for the GPS, it is important to ensure that the signal can be received without obstructions, avoiding areas where coverage may be compromised. The power supply must be connected properly to avoid interruptions in operation. The installation of the SIM card requires attention to the type of data plan used, as it will affect the device's communication with the tracking platform. Finally, verifying the operation is an essential step to ensure that everything is functioning as expected.
If you are looking for an efficient and practical solution to monitor your vehicles, consider the Trackar platform, which offers a one-time payment and comprehensive features to easily manage your Coban GPS105B.
SMS Commands
1. Start of Configuration
To begin using your device, you need to start the equipment configuration. This will ensure that all functionalities are active and working correctly.
begin123456
2. Time Zone Configuration
Adjust the time zone of your tracker so that location information is accurate. This configuration is essential for effective tracking.
time zone123456 0
3. APN Configuration
It is essential to enter the correct APN, username, and password information, as these details may vary depending on the SIM card carrier used. Update this information according to your carrier.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
Set the DNS servers that will be used by the tracker. This configuration is important to ensure proper communication of the device with the network.
Server 01, Server 02, Server 03: [insert DNS addresses here]
5. Vibration Alarm Activation
Activate the vibration alarm so that the tracker can detect unwanted movements and vibrations, providing an extra layer of security.
shock123456
6. Tracking Activation
Activate the device's tracking function so that you can monitor the location in real-time.
tracker123456
7. GPRS Transmission Activation
Enable data transmission via GPRS so that the tracker can send location and status information to the server.
gprs123456
8. Transmission Time Setting
Adjust the transmission time to 60 seconds while the equipment is in motion. This will ensure that you receive frequent updates on the location.
upload123456 060
The time can be adjusted as needed.
9. Sleep Mode by Sensor
The tracker will enter power-saving mode after 5 minutes of inactivity. It will be activated again upon detecting any movement or vibration.
sleep123456 shock
Can be activated by movement, SMS, or call.
Special commands
Special Commands
Here are some additional commands that can be used to manage the tracker.
G123456#
where
gprs123456 0
sensitivity123456
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment