Coban GPS102B Installation Manual
Introduction to the Coban GPS102B Installation Manual
The Coban GPS102B is an advanced vehicle tracking solution that offers a range of features for real-time monitoring. In this manual, we will cover the physical installation of this device, which is crucial to ensure its efficient operation.
To begin, the installation position of the GPS102B should be chosen carefully, ensuring that the device has a clear view of the sky to optimize GPS signal reception. Power supply is another fundamental point; make sure to connect the device correctly to the vehicle's power source, avoiding interference and ensuring continuous operation.
Additionally, installing the SIM card is an essential step, as it is through this that the tracker communicates with the monitoring platform. After installation, it is recommended to conduct a complete system check to ensure that the device is functioning properly and that all data is being transmitted correctly.
With the Coban GPS102B properly installed and configured, you will be able to enjoy all the advantages that a vehicle tracker can offer. For an even more complete experience, consider the Trackar platform, which requires a one-time payment and provides an intuitive interface for managing your tracking information.
SMS Commands
1. Start of Configuration
To begin using your Coban GPS102B GPS tracker, it is essential to start the device configuration. This is the first step to ensure that all functionalities are operational.
begin123456
2. Time Zone Configuration
Adjusting the time zone of your tracker is essential for accurate location information. Use the appropriate command to set the desired time zone.
time zone123456 0
3. APN Configuration
Configuring the APN (Access Point Name) is crucial for the tracker’s communication with the carrier network. APN, username, and password information may vary between different carriers, so it is important to enter the correct data.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
In this step, you must configure the DNS servers and port that will be used by the tracker. This information is essential to ensure a stable connection.
Server 01:
Server 02:
Server 03:
5. Vibration Alarm Activation
The vibration alarm is a feature that allows the device to notify the user about unexpected movements. It is an important functionality for security.
shock123456
6. Tracking Activation
For the tracker to start monitoring the location, it is necessary to activate the tracking function. This will allow you to receive real-time information.
tracker123456
7. GPRS Transmission Activation
GPRS transmission is the method by which the tracker sends data to the center. It is important to activate this function so that the information can be transmitted.
gprs123456
8. Transmission Time Setting
You can set the time interval for data transmission while the tracker is in motion. The default is 60 seconds, but it can be adjusted as needed.
upload123456 060
Adjustable time
9. Sleep Mode by Sensor
This mode allows the tracker to enter hibernation mode after 5 minutes of inactivity, saving battery. The device can be activated again by movement, SMS, or call.
sleep123456 shock
Description: The tracker will sleep after 5 minutes of inactivity. Any vibration/movement/shake will cause the tracker to 'wake up'.
Special commands
10. Special Commands
Below are some special commands that can be used for additional functionalities of the tracker.
G123456#
where
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment