Coban Coban GPS306 Installation Manual
Introduction to the Coban GPS306 Installation Manual
The Coban GPS306 is an advanced tracking device that offers effective solutions for vehicle monitoring. In this manual, we will address the physical installation of your GPS, a crucial step to ensure proper functioning and accuracy in tracking.
The installation begins with choosing the ideal position for the GPS inside the vehicle. It is essential that the device is placed in a location that minimizes obstructions and maximizes signal reception. After that, the GPS power supply must be correctly connected to the vehicle's power source, ensuring that the device receives the necessary voltage for continuous operation.
In addition to the power supply, inserting the SIM card is an important step, as it will enable communication between the device and the network. Finally, a thorough check of all connections and the functioning of the GPS is recommended before finalizing the installation.
With the Coban GPS306 properly installed, you will be ready to enjoy all the features it offers. For even more efficient tracking management, consider using the Trackar platform, which offers a one-time payment and robust features to optimize your monitoring experience.
SMS Commands
1. Start Equipment Configuration
To begin using the tracker, it is necessary to perform the initial configuration of the device. This step is crucial to ensure that the equipment functions correctly and is ready for tracking.
begin123456
2. Set Time Zone
Adjusting the time zone is essential for location data to be recorded correctly. Use the appropriate command to set your time zone.
time zone123456 0
3. Configure Carrier APN
Configuring the APN is essential for the tracker to connect to the internet. The APN, username, and password information must be adjusted according to the carrier of the SIM card used. Below are the commands for different carriers.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
Make sure to use the correct information for your carrier.
4. Configure DNS and Ports
It is important to configure the DNS servers to ensure a stable and effective connection. The details of the servers should be entered as necessary.
Server 01, Server 02, and Server 03 must be defined.
5. Activate Vibration Alarm
The vibration alarm is a feature that allows for the detection of unexpected movements. Activate it to enhance the security of your tracker.
shock123456
6. Activate Tracking
For the tracker to start sending location information, it is necessary to activate the tracking function. This will allow monitoring of the device in real time.
tracker123456
7. Activate GPRS Transmission
Activating GPRS transmission is essential for data to be sent correctly. Execute the command to ensure that the tracker connects to the network.
gprs123456
8. Set Transmission Time
Adjust the data transmission time according to your needs. The default time is 60 seconds while the equipment is in motion.
upload123456 060
9. Sleep Mode by Sensor
This mode allows the tracker to enter hibernation after 5 minutes of inactivity. Any movement will cause the device to return to active mode.
sleep123456 shock
The tracker can be activated by movement, SMS, or call.
Special commands
Special Commands
Here are some additional commands that can be used for specific functionalities of the tracker.
G123456#
where
gprs123456 0
sensitivity123456
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment