Coban Coban GPS303 Installation Manual

Introduction to the Coban GPS303 Installation Manual

The Coban GPS303 is a vehicle tracking device that combines advanced technology and ease of use, ideal for those seeking security and real-time monitoring. In this manual, we will cover the physical installation of the device, a fundamental step to ensure its correct and effective operation.

The proper installation of the Coban GPS303 involves several crucial points: choosing the position of the GPS in the vehicle, connecting the power supply, inserting the SIM card, and checking the connections. The GPS position should be chosen carefully, ensuring that the GPS signal is not obstructed, which can affect tracking accuracy. The power supply must be connected carefully, ensuring that the device receives the necessary energy to operate without failures. Additionally, installing the SIM card is essential to ensure the device's communication with the data network.

By following the instructions in this manual, you will ensure that your Coban GPS303 operates optimally, providing security and convenience. For efficient tracking, also consider the Trackar platform, which offers a one-time payment solution, facilitating the monitoring of your vehicle with cutting-edge technology.

SMS Commands

1. Start Equipment Configuration

To begin the configuration of your tracker, send the corresponding command. This will allow the device to start operating properly.

begin123456

2. Set Time Zone

It is essential to adjust the time zone of the tracker to ensure that location data is accurate. Use the appropriate command to set the configuration.

time zone123456 0

3. APN Configuration

Configuring the APN is crucial and must be done with the correct information from the carrier. Each provider may have different data for APN, username, and password. Make sure to enter the correct data.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

4. DNS and Port Configuration

To ensure a stable connection, it is necessary to configure the DNS servers and ports. The tracker must be properly configured for effective communication.

Server 01, Server 02, Server 03 must be specified.

5. Activate Vibration Alarm

The vibration alarm is an important feature that can be activated to monitor unwanted movements. Use the appropriate command to activate it.

shock123456

6. Activate Tracking

For the tracker to start sending location data, the tracking function must be activated. Send the corresponding command to initiate the process.

tracker123456

7. Activate GPRS Transmission

Data transmission via GPRS must be activated for the tracker to communicate with the servers. Use the indicated command to enable this function.

gprs123456

8. Set Transmission Time

The transmission time can be adjusted as needed. The default is 60 seconds when the device is in motion. Use the command to set this time.

upload123456 060

9. Sleep Mode by Sensor

The tracker can enter sleep mode after 5 minutes of inactivity. This mode saves battery, and the tracker will be activated by any movement, SMS, or call.

sleep123456 shock

Special commands

Special Commands

Use the following commands for additional functionalities of the tracker.

G123456#

where

gprs123456 0

sensitivity123456 + selecionar número 1, 2 ou 3!

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456