Coban A306 Installation Manual
Introduction to the Coban A306 Installation Manual
The Coban A306 model is an excellent vehicle tracking solution, providing security and real-time monitoring. To ensure optimal device operation, correct installation is essential. In this section, we will cover the essential steps for the physical installation of the GPS, including the ideal position for the device, connection to the power supply, insertion of the SIM card, and verification of operation after installation.
Choosing the GPS location is crucial; it should be placed in a discreet location but with good visibility for the satellite signal. Next, the power supply must be securely connected, ensuring that the device receives continuous power. The SIM card should be inserted carefully, ensuring it is properly seated to avoid communication issues.
Finally, we will perform a check to confirm that the Coban A306 is functioning correctly, allowing you to start enjoying all the features offered by the tracker.
To enhance your tracking experience, consider the Trackar platform, which offers a one-time payment service, facilitating efficient monitoring of your assets.
SMS Commands
1. Device Configuration Start
To start using the tracker, it is necessary to begin the equipment configuration. This ensures that all functions operate correctly.
begin123456
2. Time Zone Configuration
Adjust the tracker's time zone to ensure that location data is correct. Use the appropriate command to set the desired time zone.
time zone123456 0
3. Carrier APN Configuration
It is essential to configure your service provider's APN. APN, username, and password information may vary depending on the carrier used. Make sure to enter the correct data to ensure connectivity.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
Set the necessary DNS servers for the tracker. This configuration is essential to ensure correct communication of the device with the network.
Server 01, Server 02, Server 03 should be filled in as needed.
5. Vibration Alarm Activation
Activate the vibration alarm so that the tracker can detect movements and alert you in case of suspicious activities.
shock123456
6. Enable Tracking
Enable the device's tracking function so you can monitor the location in real time.
tracker123456
7. Enable GPRS Transmission
Activate data transmission via GPRS so that the tracker can send location and status information.
gprs123456
8. Set Transmission Time
Adjust the time interval for data transmission. The default is 60 seconds while the equipment is in motion.
upload123456 060
The time can be adjusted as needed.
9. Sleep Mode by Sensor
The tracker enters sleep mode after 5 minutes of inactivity. Any movement or vibration will reactivate it, providing battery savings.
sleep123456 shock
The device can be awakened by movement, SMS, or call.
Special commands
Special Commands
These additional commands allow extra functionalities for the tracker.
G123456#
where
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment