CCTR CCTR-810 Installation Manual

Introduction to the CCTR-810 Installation Manual

The CCTR-810 is a GPS tracking device developed by the CCTR brand, designed to provide accurate and reliable solutions for vehicle and asset monitoring. This installation manual aims to guide you in the physical setup of your device, ensuring optimal performance.

To start, it is essential to choose the correct position for the GPS installation. The location should be discreet but with good visibility for GPS signal, avoiding interferences. The device's power supply should be properly connected to the power source, ensuring that the CCTR-810 operates continuously.

Additionally, inserting the SIM card is a crucial step that must be done carefully, ensuring that the device can connect to the data network for information transmission. After installation, it is recommended to conduct a thorough check of the settings and operation of the equipment to ensure everything is functioning as expected.

If you are looking for an efficient monitoring solution, consider the Trackar platform, which offers a one-time payment for access to advanced tracking functionalities. Make the most of your CCTR-810 with this powerful tool.

SMS Commands

1. Restore Factory Settings

To return the device to its original factory state, use the appropriate command. This ensures that all custom settings are removed.

FACTORY*123456

2. Time Zone Configuration

Adjust the tracker’s time zone to ensure that recorded times are accurate. This command is essential for operations in different regions.

TIMEZONE*123456*0

3. Configure Carrier APN

APN settings must be adjusted according to the carrier of the SIM card used. It is crucial to enter the correct information to ensure the tracker’s connectivity.

APN*123456*CLARO.BR

APN*123456*CLARO.COM.BR

APN*123456*GPRS.OI.COM.BR

APN*123456*SMART.M2M.VIVO.COM.BR

APN*123456*TIMBRASIL

APN*123456*ZAP.VIVO.COM.BR

USERNAME*123456*CLARO,CLARO

USERNAME*123456*OI,OI

USERNAME*123456*TIMBRASIL,TIMBRASIL

USERNAME*123456*VIVO,VIVO

Remember that APN information varies according to the chip supplier and carrier.

4. Set DNS and Port

Define the DNS servers and communication port to ensure the tracker connects correctly to the monitoring platform.

IP*123456*central.trackar.com.br,5040

5. Tracking Mode

Choose between the available tracking modes. The default mode keeps the device always active, while the shock control mode activates and deactivates the tracker according to movement.

MODE*123456*1

MODE*123456*2

Mode 1 is the default, while mode 2 saves battery by turning off the tracker when not in motion.

6. Set Upload Interval

Adjust the time in seconds for the data upload interval. The minimum interval is 30 seconds and the maximum is 999 seconds.

INTERVAL*123456*60

The factory default is 30 seconds.

Special commands

Special Commands

Use special commands to perform additional functions and maintain control of the tracker.

CHECK*123456

URL*123456

CHECKPHONE*123456

CHECKPASSWORD#

ALARM*123456

RESET*123456

KEEPONLINE*123456

SHOCKCONTROLGPRS*123456