Installation manual for the CCTR CCTR-800G

Introduction to the CCTR CCTR-800G Installation Manual

The CCTR CCTR-800G is a state-of-the-art GPS tracking device designed to provide accuracy and reliability in locating vehicles and objects. This manual aims to guide you through the physical installation process of your new equipment, addressing essential aspects such as the ideal position for GPS installation, connection to power supply, SIM card insertion, and verification of device operation.

Choosing the location for the CCTR-800G is crucial to ensure the best performance of the tracker. We recommend that the device be installed in a discreet and protected location that minimizes signal interference. Additionally, it is essential to correctly connect the device to the power supply to ensure its continuous operation.

The insertion of the SIM card should be done carefully, and it is important to verify that the device is operating properly after installation. Follow the instructions in this manual to ensure that all steps are completed successfully.

Finally, explore the Trackar platform, which offers an efficient tracking system with a one-time payment, ideal for managing the location of your CCTR CCTR-800G in a practical and effective manner.

SMS Commands

1. Restore Factory Settings

To restore the factory settings of the device, use the appropriate command. This is useful if you want to reset all settings to the original default.

FACTORY*123456

2. Timezone Configuration

Adjust the tracker’s timezone to ensure that location data is recorded correctly. The command should include the desired time setting.

TIMEZONE*123456*0

3. Configure Carrier APN

It is crucial that the APN, username, and password information is updated correctly, as they vary according to the chip provider and carrier. Use the commands below to set the necessary APNs.

APN*123456*CLARO.BR

APN*123456*CLARO.COM.BR

APN*123456*GPRS.OI.COM.BR

APN*123456*SMART.M2M.VIVO.COM.BR

APN*123456*TIMBRASIL

APN*123456*ZAP.VIVO.COM.BR

USERNAME*123456*CLARO,CLARO

USERNAME*123456*OI,OI

USERNAME*123456*TIMBRASIL,TIMBRASIL

USERNAME*123456*VIVO,VIVO

Ensure that the information is correct to avoid connectivity issues.

4. Configure DNS and Port

Set the DNS servers and ports that the tracker will use to connect. This is important to ensure that the device can communicate correctly with the servers.

IP*123456*central.trackar.com.br,5015

5. Tracking Mode

Choose the tracking mode that best fits your needs. Mode 1 keeps the tracker always active, while Mode 2 saves battery by turning off the device when not in motion.

MODE*123456*1

MODE*123456*2

Consider using Mode 2 to save battery, but be aware that the tracker will not respond to commands when in standby mode.

6. Set Upload Interval

Adjust the data upload interval, which can be set between 30 and 999 seconds. Set a value that balances update frequency and battery consumption.

INTERVAL*123456*60

Special commands

7. Special Commands

Below are some special commands that can be used to manage the tracker effectively.

CHECK*123456

URL*123456

CHECKPHONE*123456

CHECKPASSWORD#

ALARM*123456

RESET*123456

KEEPONLINE*123456

SHOCKCONTROLGPRS*123456

These commands are useful for checking settings, restarting the device, and maintaining connectivity.