CCTR CCTR-800 Installation Manual

Introduction to the CCTR CCTR-800 Installation Manual

The CCTR CCTR-800 is an advanced GPS tracking device designed to provide precision and reliability in your monitoring operations. In this manual, we will address the physical installation of the device, covering essential aspects such as the ideal GPS position, power connection, SIM card insertion, and the necessary verification procedures to ensure proper functioning.

Choosing the GPS position is crucial to ensure that the signal is received efficiently, avoiding obstructions that could compromise the device's performance. Additionally, it is important to make the correct power connection, ensuring that the CCTR-800 operates continuously and without failures. The installation of the SIM card should be done carefully, following specific guidelines to avoid damaging the device.

After installation, it is crucial to perform a complete check to confirm that all functions of the CCTR-800 are operational. With these steps, you will be prepared to explore the full potential of your GPS tracker.

For an even more complete experience, consider using the Trackar platform, which offers an efficient monitoring system with a one-time payment. Explore the possibilities that the CCTR CCTR-800 and Trackar can provide in managing your fleet or personal belongings.

SMS Commands

1. Restore Factory Settings

To return the device to its original settings, use the appropriate command. This is useful for troubleshooting or resetting the device for new use.

FACTORY*123456

2. Set Time Zone

Adjust the tracker’s time zone to ensure that location information is accurate. Use the indicated command to set the desired time zone.

TIMEZONE*123456*0

3. Configure Carrier APN

It is essential to correctly configure the APN, username, and password, as this information varies depending on the chip provider and carrier. Ensure that the data is correct for effective connectivity.

APN*123456*CLARO.BR

APN*123456*CLARO.COM.BR

APN*123456*GPRS.OI.COM.BR

APN*123456*SMART.M2M.VIVO.COM.BR

APN*123456*TIMBRASIL

APN*123456*ZAP.VIVO.COM.BR

USERNAME*123456*CLARO,CLARO

USERNAME*123456*OI,OI

USERNAME*123456*TIMBRASIL,TIMBRASIL

USERNAME*123456*VIVO,VIVO

Make sure to enter the exact data from your carrier.

4. Set DNS and Port

Set the DNS servers and port to ensure that the tracker can communicate correctly with the tracking server.

IP*123456*central.trackar.com.br,5040

5. Tracking Mode

Choose between the available tracking modes. Mode 1 is the default, while Mode 2 offers more dynamic control, activating the tracker only when in motion.

MODE*123456*1

MODE*123456*2

Mode 2 can save battery but limits the device's responsiveness.

6. Set Upload Interval

Adjust the time interval for data uploads. The interval can be set between 30 and 999 seconds, depending on monitoring needs.

INTERVAL*123456*60

The default interval is 30 seconds.

Special commands

Special Commands

Use the following commands to perform specific functions on the tracker.

CHECK*123456

URL*123456

CHECKPHONE*123456

CHECKPASSWORD#

ALARM*123456

RESET*123456

KEEPONLINE*123456

SHOCKCONTROLGPRS*123456

FACTORY*123456

These commands offer a variety of functions, from checking settings to restarting the device.