Installation Manual for CCTR CCTR-622G

Introduction to the Installation Manual for the CCTR CCTR-622G

The CCTR CCTR-622G is a GPS tracking device designed to provide effective solutions for monitoring and locating vehicles. To ensure the proper functioning of your device, correct installation is essential. In this manual, we will cover the essential steps for the physical installation of the CCTR-622G, including choosing the GPS position, connecting to the power supply, inserting the SIM card, and final system verification.

The GPS position is crucial for optimizing signal reception and tracking accuracy. Make sure to install the device in a location that minimizes obstructions, such as under the dashboard or in hidden areas of the vehicle. The power supply should be connected properly to ensure that the device operates continuously, while the SIM card installation should be done carefully, ensuring that all contacts are firm and secure.

After the physical installation, a complete check is recommended to ensure that the CCTR-622G is operating correctly and transmitting data as expected. With these steps, you will be ready to take full advantage of your tracker’s potential.

For an even more complete experience, consider the Trackar platform, which offers a one-time payment and an intuitive interface to easily manage your trackers.

SMS Commands

1. Restore factory settings

To restore the device to factory settings, use the indicated command. This is essential if you need to reconfigure or troubleshoot the tracker.

FACTORY*123456

2. Set time zone

Adjusting the time zone is crucial to ensure that location information is accurate. Use the corresponding command to set the desired time zone.

TIMEZONE*123456*0

3. Carrier APN configuration

Correct APN configuration, along with the username and password, is crucial for the tracker to function. The information varies by carrier, so make sure to enter the correct data.

APN*123456*CLARO.BR

APN*123456*CLARO.COM.BR

APN*123456*GPRS.OI.COM.BR

APN*123456*SMART.M2M.VIVO.COM.BR

APN*123456*TIMBRASIL

APN*123456*ZAP.VIVO.COM.BR

USERNAME*123456*CLARO,CLARO

USERNAME*123456*OI,OI

USERNAME*123456*TIMBRASIL,TIMBRASIL

USERNAME*123456*VIVO,VIVO

Remember to check if the APN is correct for the chip used.

4. Set DNS and Port

Define the DNS servers and port to ensure that the tracker connects correctly to the network. It is important that the addresses are correct to avoid communication issues.

IP*123456*central.trackar.com.br,5013

5. Select tracking mode

Choose between different tracking modes according to your needs. The standard mode allows continuous operation, while the shock control mode saves battery.

MODE*123456*1

MODE*123456*2

Mode 2 turns off the tracker after 5 minutes of inactivity.

6. Set upload interval

Adjust the upload time in seconds, with a minimum of 30 and a maximum of 999. The factory default is 30 seconds.

INTERVAL*123456*60

Special commands

7. Special commands

Use the special commands below to access additional settings and perform specific operations on the tracker.

CHECK*123456

URL*123456

CHECKPHONE*123456

CHECKPASSWORD#

ALARM*123456

RESET*123456

KEEPONLINE*123456

SHOCKCONTROLGPRS*123456