How to Set Up the Coban TK-905 Device via SMS

This guide shows how to connect the Coban TK-905 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.

SMS Commands

1. Start Equipment Setup

To begin the configuration of your GPS tracker, send the initial command. This is essential for the device to operate correctly.

begin123456

2. Set Time Zone

Adjust the tracker’s time zone to ensure that location data is accurate. The command must be sent with the desired time zone value.

time zone123456 0

3. Configure Carrier APN

It is essential to correctly configure the APN, username, and password according to your carrier's specifications. This will ensure the tracker’s connectivity.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

APN information may vary depending on the chip provider and the carrier used.

4. Configure DNS and Port

It is necessary to define the DNS servers and the ports that the tracker will use for communication. The information should be filled in as per your needs.

Server 01, Server 02, Server 03: fill in as necessary.

5. Activate Vibration Alarm

To activate the vibration alarm, send the corresponding command. This will help monitor unexpected movements of the vehicle.

shock123456

6. Activate Tracking

Send the command to activate the tracking of the device. This will allow you to monitor the location in real-time.

tracker123456

7. Activate GPRS Transmission

For the tracker to send location data, it is necessary to activate transmission via GPRS. Send the appropriate command.

gprs123456

8. Set Transmission Time

Adjust the data transmission interval. The default is 60 seconds when the equipment is in motion.

upload123456 060

9. Sleep Mode by Sensor

The tracker will enter hibernation mode after 5 minutes of inactivity. Any movement or vibration will reactivate it.

sleep123456 shock

The wake-up mode can be activated by movement, SMS, or call.

Special commands

Special Commands

Here are some additional commands that can be used for specific functions of the tracker.

G123456#

where

gprs123456 0

sensitivity123456 + selecionar número 1, 2 ou 3!

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456