How to configure the Coban GPS105B tracker

Configuring the Coban GPS105B tracker is a crucial step to ensure effective monitoring of vehicles and valuable objects. This advanced device offers robust functionalities, but to extract the maximum potential, proper configuration is necessary. In this introduction, we will address the main aspects of configuration, including the definition of the APN (Access Point Name), which is essential for the device to connect to the mobile data network. Additionally, we will discuss the configuration of the DNS server, which is fundamental for communication between the tracker and the monitoring platform.

Another important point is the IMEI (International Mobile Equipment Identity), which must be correctly entered for the tracker to function properly and be identified on the network. Finally, we will talk about conducting tests, which ensure that all configurations are working as expected, providing a smooth and efficient tracking experience. With the Coban GPS105B properly configured, you will have full control over the location and security of your asset.

For even more effective management, consider the Trackar platform, which offers a one-time payment solution for continuous monitoring.

SMS Commands

1. Start of Configuration

To begin using your device, you need to start the equipment configuration. This will ensure that all functionalities are active and working correctly.

begin123456

2. Time Zone Configuration

Adjust the time zone of your tracker so that location information is accurate. This configuration is essential for effective tracking.

time zone123456 0

3. APN Configuration

It is essential to enter the correct APN, username, and password information, as these details may vary depending on the SIM card carrier used. Update this information according to your carrier.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

4. DNS and Port Configuration

Set the DNS servers that will be used by the tracker. This configuration is important to ensure proper communication of the device with the network.

Server 01, Server 02, Server 03: [insert DNS addresses here]

5. Vibration Alarm Activation

Activate the vibration alarm so that the tracker can detect unwanted movements and vibrations, providing an extra layer of security.

shock123456

6. Tracking Activation

Activate the device's tracking function so that you can monitor the location in real-time.

tracker123456

7. GPRS Transmission Activation

Enable data transmission via GPRS so that the tracker can send location and status information to the server.

gprs123456

8. Transmission Time Setting

Adjust the transmission time to 60 seconds while the equipment is in motion. This will ensure that you receive frequent updates on the location.

upload123456 060

The time can be adjusted as needed.

9. Sleep Mode by Sensor

The tracker will enter power-saving mode after 5 minutes of inactivity. It will be activated again upon detecting any movement or vibration.

sleep123456 shock

Can be activated by movement, SMS, or call.

Special commands

Special Commands

Here are some additional commands that can be used to manage the tracker.

G123456#

where

gprs123456 0

sensitivity123456

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456