How to Configure the Coban GPS104 Tracker

Configuring the Coban GPS104 tracker is a crucial step to ensure its effective operation and accuracy in locating vehicles. This device allows real-time monitoring, but for this to happen, it is necessary to configure some essential parameters, such as APN, DNS server, and the device's IMEI. The correct configuration of these elements ensures communication between the tracker and the tracking platform.

The configuration process may seem a bit complex for beginners, but with a step-by-step guide, you can quickly adjust the necessary settings. After the initial configuration, it is important to conduct tests to verify that the device is transmitting data correctly. This will ensure that you can track your vehicle's location without interruptions.

If you are looking for a complete solution for vehicle tracking, consider using the Trackar platform, which offers a one-time payment and a user-friendly interface to facilitate its use. Don't waste time and start monitoring your vehicle efficiently!

SMS Commands

1. Start of Equipment Configuration

To begin using the tracker, it is necessary to start the device configuration. This will ensure that all functions are active and ready for use.

begin123456

2. Time Zone Configuration

Adjust the time zone of your tracker to ensure that location information is accurate. Use the appropriate command to set the desired time zone.

time zone123456 0

3. Carrier APN Configuration

It is essential to correctly configure the APN, username, and password, as this information varies depending on the chip carrier used. Verify the correct data before sending the commands.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

4. DNS and Port Configuration

Configure the DNS servers and the port to ensure the connectivity of the tracker. It is important that this data is accurate for proper functioning.

Server 01, Server 02, Server 03 must be filled with the correct information.

5. Vibration Alarm Activation

Activate the vibration alarm so that the tracker can alert you in case of unexpected movements. This function is essential for safety.

shock123456

6. Tracking Activation

For the tracker to start functioning, it is necessary to activate the tracking function. This will allow you to monitor the device's location.

tracker123456

7. GPRS Transmission Activation

Enable GPRS transmission so that the tracker can send location data in real-time. This configuration is crucial for efficient tracking.

gprs123456

8. Transmission Time Definition

Set the time interval for data transmission. The default time is 60 seconds while the device is in motion.

upload123456 060

The time can be adjusted as needed.

9. Sleep Mode by Sensor

The tracker enters sleep mode after 5 minutes of inactivity. Any movement or vibration will cause the device to return to active mode.

sleep123456 shock

The activation mode can be by movement, SMS, or call.

Special commands

Special Commands

Below are some special commands that can be used for additional functionalities of the tracker.

G123456#

where

gprs123456 0

sensitivity123456 + selecionar número 1, 2 ou 3!

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456