How to Configure the Suntech: T3 Device via SMS
This guide shows how to connect the Suntech: T3 tracker to the platform using SMS commands. Send each command from the chip installed in the device, in the order indicated below.
SMS Commands
2. Network Parameter Configuration
Below are the commands to configure the network parameters of the tracker. Choose the appropriate server according to the chip carrier. Correct configuration is crucial for the proper functioning of the tracker.
ST300NTW;XXXXXXXXX;02;0;smart.m2m.vivo.com.br;vivo;vivo;central.trackar.com.br;6011;central.trackar.com.br;6011;0;0
ST300NTW;XXXXXXXXX;02;0;hinova.br;vivo;vivo;central.trackar.com.br;6011;central.trackar.com.br;6011;0;0
ST300NTW;XXXXXXXXX;02;0;transmeet.br;transmeet;transmeet;central.trackar.com.br;6011;central.trackar.com.br;6011;0;0
Check if the network information is correct and up to date.
3. Sending and Event Parameters
These commands are specific for configuring the data sending frequencies and events of the tracker. The choice between the settings for car or motorcycle should be made based on the type of vehicle being monitored.
ST300RPT;XXXXXXXXX;02;3300;60;60;3;300;300;0;0;0
ST300EVT;XXXXXXXXX;02;0;10;0;12;11;9;30;30;0;0;7;1;1;0;0;0;0;0;0;9;9;0;0;0
Incorrect adjustments may affect the efficiency of the tracker.
4. Battery and Sensor Settings
The following commands are used to optimize battery usage and configure the sensors of the tracker. Energy efficiency is essential to ensure prolonged operation of the device.
ST300BAT;XXXXXXXXX;02;0;3.4
ST300CMD;XXXXXXXXX;02;ImproveBatteryLife=1
Proper battery maintenance prolongs the lifespan of the tracker.
Special commands
1. Reset and Configuration Commands
The following commands are used to restore factory settings and make adjustments to the module. It is important to replace 'XXXXXXXXX' with the last 9 digits of the device's IMEI, as indicated. The commands vary according to the carrier of the chip used.
ST300CMD;XXXXXXXXX;02;Reset
ST300CMD;XXXXXXXXX;02;EraseAll
ST300CMD;XXXXXXXXX;02;Reboot
Make sure the device is connected to the network before executing the commands. ### 5. Special Commands
These commands are used for additional functions, such as requesting the position of the tracker or setting the odometer. Use them as needed to manage the device.
ST300CMD;XXXXXXXXX;02;StatusReq
ST300CMD;XXXXXXXXX;02;Preset
ST300CMD;XXXXXXXXX;02;SetOdometer=XXXXXXXXX000
Make sure the tracker is properly configured before sending special commands.
Own your tracking platform with a one-time payment