How to configure the Concox Start S-2013 device via SMS

This guide shows how to connect the Concox Start S-2013 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.

SMS Commands

1. Time Zone Configuration

To ensure that the tracker works correctly, it is essential that the time zone is configured. The configuration must be done through the appropriate command.

GMT,W,0,0#

2. Update Interval Configuration

The update interval of the tracker can be adjusted in seconds. It is possible to set different intervals for when the vehicle is in motion and when it is stationary.

TIMER,20,20#

3. Angle-Based Update

The location update of the tracker can be configured based on a specific angle and an adjustable detection time. This allows for greater accuracy in location.

ANGLEREP,ON,30,2#

4. Heartbeat Configuration

The heartbeat is a signal of life that the tracker sends at regular intervals. It is possible to adjust these intervals based on the vehicle's ignition state.

HB,1,55#

5. Server Configuration

It is necessary to configure the server address and port for the tracker to send data correctly. Make sure the information is accurate.

SERVER,1,central.trackar.com.br,5019,0#

6. APN Configuration

APN, username, and password settings are fundamental and must be entered correctly according to the carrier of the used chip.

APN,AGILIS.ALGAR.BR#

APN,ALLCOM.ALGAR.BR#

APN,ALLCOM.BR#

APN,ALLCOM.VIVO.COM.BR#

APN,CLARO.COM.BR#

APN,DATATEM.ALGAR.BR#

APN,ESEYE.COM#

APN,GPRS.OI.COM.BR,OI,OI#

APN,GPRS.TELEMIGCELULAR.COM.BR#

APN,IOT4U.BR#

APN,JBGPRS.BR#

APN,LINKSOLUTIONS.BR#

APN,M2DATA.ALGAR.BR#

APN,M2DATA.ARQIA.BR#

APN,M2DATA.VIVO.COM.BR#

APN,M2M.VODAFONE.BR#

APN,M2TRACK.BR#

APN,OKTOR.BR#

APN,SMART.M2M.VIVO.COM.BR#

APN,SS.ALGAR.BR#

APN,TIM.BR,TIM,TIM#

APN,TRANSMEET.BR#

APN,VIRTUEYES.VIVO.COM.BR#

APN,VOXTER.ALGAR.BR#

APN,VOXTER.BR#

APN,ZAP.VIVO.COM.BR#

APN.BRT.BR#

APN.META.VIVO.COM.BR#

7. Forced Position Sending

To ensure that positions are sent, you can force the tracker to send data for a period of 5 minutes. This is useful for functionality testing.

LJDW#

Special commands

Special Commands

Here are some special commands that can be used for different functions of the tracker.

PARAM#

GPRSSET#

STATUS#

STA_SENDGPS,1#

STA_SENDGPS,0#

STA_SENDGPS#

SENDS,0#

SOS,A,XXXXXXXXXXX#

CENTER,A,XXXXXXXXXXX#

CENTER,D#

SOS,D,XXXXXXXXXXX#

RELAY,1#

RELAY,0#

ANGLEREP,ON,30,2#

ICCID#

HBT,1,55#

DW#

WHERE#

RESET#

FACTORY#

Note: the use of some commands may affect the vehicle's battery consumption.