How to configure the Coban TK909 device via SMS
This guide shows how to connect the Coban TK909 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.
SMS Commands
1. Start of Configuration
To start using the tracker, it is necessary to perform the initial configuration of the device. This step is crucial to ensure that all functionalities operate correctly.
begin123456
2. Time Zone Configuration
It is essential to adjust the time zone of the tracker so that location information is accurate. The following command must be sent to configure the desired time zone.
time zone123456 0
3. APN Configuration
Configuring the APN is essential for the tracker to connect to the carrier's network. The APN, username, and password information varies according to the chip provider used. Make sure to enter the correct data.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
To ensure efficient communication, it is necessary to configure the DNS servers and ports. These parameters must be defined according to your service provider's specifications.
Server 01: Server 02: Server 03:
5. Vibration Alarm Activation
The vibration alarm can be activated to alert you about unexpected movements of the device. Use the command below to enable this function.
shock123456
6. Tracking Activation
To start tracking the device, it is necessary to activate this function using the appropriate command. This will allow you to monitor the location of the tracker in real-time.
tracker123456
7. GPRS Transmission Activation
The communication of the tracker with the server is done via GPRS. To ensure that this functionality is active, send the indicated command.
gprs123456
8. Transmission Time Definition
The transmission time can be adjusted as needed. The default is 60 seconds while the equipment is in motion. Use the command below to set the desired interval.
upload123456 060
9. Sensor Sleep Mode
The tracker can enter sleep mode after 5 minutes of inactivity. It will be activated again upon detecting any movement, vibration, or receiving an SMS or call. This function helps to save battery.
sleep123456 shock
Special commands
Special Commands
There are additional commands that can be used for various functions of the tracker. Check the list below:
G123456#
where
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment