How to Configure the Coban TK103B Device via SMS

This guide shows how to connect the Coban TK103B tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.

SMS Commands

1. Start Equipment Setup

To begin using the GPS tracker, it is essential to start the equipment setup. This will ensure that all functionalities are available and working correctly.

begin123456

2. Set Time Zone

Adjusting the time zone of the tracker is crucial for accurate location information. You should set the time zone according to your current location.

time zone123456 0

3. Configure Carrier APN

Configuring the APN (Access Point Name) is essential for the tracker to connect to the carrier's network. It is important to enter the correct information, which may vary depending on the chip provider and the carrier used.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

Make sure to enter the correct APN to ensure connectivity.

4. Configure DNS and Port

It is necessary to configure the DNS servers and the port to ensure that the tracker functions properly. Enter the information as needed.

Server 01, Server 02, and Server 03 must be filled with the appropriate data.

5. Activate Vibration Alarm

The vibration alarm is an important feature that alerts about unexpected movements. Activate this feature for greater security.

shock123456

6. Activate Tracking

For the tracker to start monitoring the location in real-time, it is necessary to activate the tracking function.

tracker123456

7. Activate GPRS Transmission

Data transmission via GPRS must be activated for the tracker to send location information to the monitoring platform.

gprs123456

8. Set Transmission Time

You can adjust the interval at which the tracker will send location data. The default is 60 seconds while the equipment is in motion.

upload123456 060

The transmission time configuration should be done according to the monitoring needs.

9. Sleep Mode by Sensor

This mode allows the tracker to enter power-saving mode after 5 minutes of inactivity. The device will be activated by any movement, vibration, or incoming call.

sleep123456 shock

The tracker can be awakened through movement, SMS, or call.

Special commands

10. Special Commands

There are special commands that can be used for additional functionalities of the tracker. Check below.

G123456#

where

gprs123456 0

sensitivity123456 + selecionar número 1, 2 ou 3!

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456

These commands allow you to customize and optimize the use of the tracker.