How to Configure the Coban GPS104 Device via SMS
This guide shows how to connect the Coban GPS104 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.
SMS Commands
1. Start of Equipment Configuration
To begin using the tracker, it is necessary to start the device configuration. This will ensure that all functions are active and ready for use.
begin123456
2. Time Zone Configuration
Adjust the time zone of your tracker to ensure that location information is accurate. Use the appropriate command to set the desired time zone.
time zone123456 0
3. Carrier APN Configuration
It is essential to correctly configure the APN, username, and password, as this information varies depending on the chip carrier used. Verify the correct data before sending the commands.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
Configure the DNS servers and the port to ensure the connectivity of the tracker. It is important that this data is accurate for proper functioning.
Server 01, Server 02, Server 03 must be filled with the correct information.
5. Vibration Alarm Activation
Activate the vibration alarm so that the tracker can alert you in case of unexpected movements. This function is essential for safety.
shock123456
6. Tracking Activation
For the tracker to start functioning, it is necessary to activate the tracking function. This will allow you to monitor the device's location.
tracker123456
7. GPRS Transmission Activation
Enable GPRS transmission so that the tracker can send location data in real-time. This configuration is crucial for efficient tracking.
gprs123456
8. Transmission Time Definition
Set the time interval for data transmission. The default time is 60 seconds while the device is in motion.
upload123456 060
The time can be adjusted as needed.
9. Sleep Mode by Sensor
The tracker enters sleep mode after 5 minutes of inactivity. Any movement or vibration will cause the device to return to active mode.
sleep123456 shock
The activation mode can be by movement, SMS, or call.
Special commands
Special Commands
Below are some special commands that can be used for additional functionalities of the tracker.
G123456#
where
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment