How to Configure the Coban GPS-103 Device via SMS
This guide shows how to connect the Coban GPS-103 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.
SMS Commands
1. Start of Configuration
To begin the configuration of your GPS tracker, you must send a specific command that activates the system. This step is crucial for the device to start operating correctly.
begin123456
2. Time Zone Configuration
Adjust the time zone of your device to ensure that the location information is correct. This command should be sent after the initial activation.
time zone123456 0
3. APN Configuration
It is essential to configure the correct APN of the carrier used. The APN, username, and password information may vary according to the carrier, so make sure to use the correct data.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
In this step, you must configure the DNS servers that the tracker will use. It is important to have the correct data to ensure the communication of the device.
Server 01, Server 02, Server 03: information to be filled in.
5. Vibration Alarm Activation
Activate the vibration alarm so that the device can detect unwanted movements. This feature is essential for the safety of the tracker.
shock123456
6. Tracking Activation
For the tracker to start sending location information, you must activate the tracking function. This command is essential for the operation of the device.
tracker123456
7. GPRS Transmission Activation
Activate data transmission via GPRS to allow the tracker to send information in real-time. This configuration is fundamental for continuous monitoring.
gprs123456
8. Transmission Time Setting
Configure the time interval for data transmission. The default is 60 seconds, and you can adjust it as needed.
upload123456 060
The time can be adjusted as needed.
9. Sensor Sleep Mode
The tracker enters power-saving mode after 5 minutes of inactivity. It can be activated again by movement, SMS, or call.
sleep123456 shock
Special commands
10. Special Commands
Here are some special commands that can be used for additional functionalities of the tracker.
G123456#
where
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment