How to configure the Coban Coban GPS305 device via SMS
This guide shows how to connect the Coban Coban GPS305 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.
SMS Commands
1. Start of Equipment Configuration
To start the configuration of the Coban GPS305 tracker, it is essential to send an initial command that activates the device. This step is crucial to ensure that all subsequent settings are applied correctly.
begin123456
2. Time Zone Configuration
Adjusting the time zone of the tracker is essential for accurate location data. The command must be sent with the correct value of the desired time zone, which can be adjusted according to the location.
time zone123456 0
3. Carrier APN Configuration
Configuring the APN is a critical step that allows the tracker to connect to the carrier's data network. It is important to remember that APN, username, and password information varies according to the chip supplier and the carrier used. Therefore, the correct data must be entered to ensure connectivity.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. DNS and Port Configuration
Configuring the DNS servers is an important step to ensure that the tracker functions correctly. Although the specific commands for the servers are not listed, it is necessary to enter the correct addresses for the proper functioning of the device.
Server 01, Server 02, Server 03 must be defined.
5. Vibration Alarm Activation
The vibration alarm is a feature that allows the tracker to notify the user in case of unexpected movements. This command must be activated to ensure that the device is always monitoring any suspicious activity.
shock123456
6. Tracking Activation
For the tracker to start sending location data, it is necessary to activate the tracking function. This command ensures that the device is always sending information about its position.
tracker123456
7. GPRS Transmission Activation
GPRS transmission must be activated for the tracker to send location data to the server. This is an essential step to ensure that all information is transmitted correctly.
gprs123456
8. Transmission Time Setting
The transmission time can be adjusted to optimize data usage and the efficiency of the tracker. The default value is 60 seconds, but it can be adjusted according to the user's needs.
upload123456 060
Transmission time set to 60 seconds with the device in motion.
9. Sleep Mode by Sensor
This mode allows the tracker to enter a low power consumption state after 5 minutes of inactivity. The device will be activated again upon detecting movements, vibrations, or receiving an SMS or call.
sleep123456 shock
The tracker wakes up with movement, SMS, or call.
Special commands
Special Commands
In addition to the basic commands, there are special commands that allow additional functionalities for the tracker. These commands can be used to obtain specific information or change settings more directly.
G123456#
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment