How to configure the Coban Coban GPS302 device via SMS

This guide shows how to connect the Coban Coban GPS302 tracker to the platform using SMS commands. Send each command from the chip installed in the device, in the order indicated below.

SMS Commands

1. Device Configuration Start

To start the configuration of the Coban GPS302 tracker, use the start command. This is essential to ensure that the device is ready to receive the next instructions.

begin123456

2. Time Zone Configuration

Adjust the time zone of your tracker to ensure that location information is accurate. Use the appropriate command followed by the desired time zone value.

time zone123456 0

3. Carrier APN Configuration

It is crucial to update the APN, username, and password information according to the carrier of the chip used. Settings may vary, so make sure to enter the correct data.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

4. DNS and Port Configuration

Set the necessary DNS servers for the proper functioning of the tracker. It is important to ensure that these values are correct to avoid connectivity issues.

Server 01, Server 02, Server 03: Enter the data as needed.

5. Vibration Alarm Activation

Activate the vibration alarm so that the device can alert you about unwanted movements. This feature is useful for additional security.

shock123456

6. Enable Tracking

Activate the tracking function of your device to monitor its location in real-time. This is one of the main functionalities of the tracker.

tracker123456

7. GPRS Transmission Activation

Enable data transmission via GPRS so that the tracker can send location information to the server.

gprs123456

8. Set Transmission Time

Adjust the transmission time to 60 seconds while the device is in motion. This helps optimize the frequency of location updates.

upload123456 060

9. Sensor Sleep Mode

Configure the tracker to enter hibernation mode after 5 minutes of inactivity. The device will be activated again by any movement, SMS, or call.

sleep123456 shock

Special commands

10. Special Commands

Use the following special commands for additional functionalities of the tracker.

G123456#

where

gprs123456 0

sensitivity123456 + selecionar número 1, 2 ou 3!

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456