How to configure the Coban Coban GPS107 device via SMS
This guide shows how to connect the Coban Coban GPS107 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.
SMS Commands
1. Start Equipment Configuration
To begin using the tracker, it is necessary to start the device configuration. This will ensure that all functions of the tracker are operational and ready for use.
begin123456
2. Set Time Zone
It is important to adjust the time zone of the tracker so that location and event times are recorded correctly. Use the appropriate command to set the desired time zone.
time zone123456 0
3. Set Carrier APN
Configuring the APN is crucial for the operation of the tracker. You must enter the correct APN, username, and password information, which vary according to the carrier of the chip used. Make sure to use the correct data.
apn123456 allcom.br
apn123456 linksolutions.br
apn123456 m2data.arqia.br
apn123456 smart.m2m.vivo.com.br
apn123456 tim.br
apn123456 transmeet.br
apn123456 virtueyes.com.br
apn123456 zap.vivo.com.br
4. Set DNS and Port
Configuring the DNS and ports is essential to ensure proper communication of the tracker with the network. It is necessary to define the DNS servers for the connection to work properly.
Server 01, Server 02, Server 03: set as needed.
5. Activate Vibration Alarm
The vibration alarm is an important feature that alerts about unwanted movements. Activate this function to ensure the safety of your device.
shock123456
6. Activate Tracking
For the tracker to function properly, it is essential to activate the tracking function. This will allow you to monitor the device's location in real-time.
tracker123456
7. Activate GPRS Transmission
GPRS transmission must be activated for the tracker to send location data and other information. This configuration is fundamental for the operation of the device.
gprs123456
8. Set Transmission Time
You can adjust the data transmission interval of the tracker. It is possible to set a time of 60 seconds for the tracker to send information while in motion.
upload123456 060
The transmission time is adjustable according to your needs.
9. Sleep Mode by Sensor
This mode allows the tracker to enter sleep mode after 5 minutes of inactivity. Any movement or vibration will cause the device to return to an active state. This function helps save battery.
sleep123456 shock
The tracker can be awakened by movement, SMS, or call.
Special commands
Special Commands
Here are some special commands that can be used for additional functions of the tracker.
G123456#
where
gprs123456 0
sensitivity123456 + selecionar número 1, 2 ou 3!
check123456
speed123456 080
nospeed123456
shock123456
noshock123456
lowbatsms123456 on
sleep123456 time
sleep123456 shock
sleep123456 off
imei123456
reset123456
Own your tracking platform with a one-time payment