How to configure the Coban Coban GPS106 device via SMS

This guide shows how to connect the Coban Coban GPS106 tracker to the platform using SMS commands. Send each command from the SIM card installed in the device, in the order indicated below.

SMS Commands

1. Start of Configuration

To start using the tracker, it is necessary to perform the initial configuration of the equipment. Use the appropriate command to begin the process.

begin123456

2. Time Zone Configuration

Adjust the time zone of the tracker to ensure that location data is accurate. Use the indicated command to set the desired time zone.

time zone123456 0

3. APN Configuration

It is crucial to update the APN, username, and password settings according to the specifications of the chip provider used. The information may vary according to the supplier.

apn123456 allcom.br

apn123456 linksolutions.br

apn123456 m2data.arqia.br

apn123456 smart.m2m.vivo.com.br

apn123456 tim.br

apn123456 transmeet.br

apn123456 virtueyes.com.br

apn123456 zap.vivo.com.br

4. DNS and Port Configuration

Configuring the DNS servers is an important step for the tracker’s communication. Make sure to enter the correct addresses to ensure proper functioning.

Server 01: Server 02: Server 03:

5. Vibration Alarm Activation

Configure the alarm that will be triggered in case of unexpected vibrations. This feature is useful for alerting about possible theft attempts or unauthorized movement of the vehicle.

shock123456

6. Tracking Activation

For the tracker to start functioning and send location information, it is necessary to activate the tracking function. Use the indicated command for this configuration.

tracker123456

7. GPRS Transmission Activation

Enable data transmission via GPRS so that the tracker can send location information in real-time. This step is essential for the device's operation.

gprs123456

8. Transmission Time Setting

Adjust the time interval for data transmission while the equipment is in motion. The default is 60 seconds, but it can be changed as needed.

upload123456 060

Adjustable time

9. Sleep Mode by Sensor

The tracker enters sleep mode after 5 minutes of inactivity. Any movement or vibration will cause it to return to active state. This mode helps save battery.

sleep123456 shock

Wake-up mode: Movement, SMS, or CALL.

Special commands

Special Commands

Here are some special commands that can be used for various functions of the tracker.

G123456#

where

gprs123456 0

sensitivity123456 + selecionar número 1, 2 ou 3!

check123456

speed123456 080

nospeed123456

shock123456

noshock123456

lowbatsms123456 on

sleep123456 time

sleep123456 shock

sleep123456 off

imei123456

reset123456